• 1" x 6" • 1-1/2" x 6" • 1" x 8"
• 1-1/2" x 8" • 1" x 10" • 1-1/2" x 10"
We can cut to size
and Pre-Slot most blades
We make replacement blades that
Reduces Road Surface and
Squeegee Cleaning Action
Provides Longer Life
Ideal for Road & Bridges,
Airport Runways, Parking Lots and Walkways
(Other sizes available upon request)
We also stock 1/4" Reinforced
Rubber for snow deflection and
Hydraulic Quick Disconnects
POLYURETHANE & RUBBER SNOW
Installation and Technical Data
Sizes: Snowplow Blades are stocked in the following standard gauges:
1"x6" , 1 1/2"x8", 1 1/2"x10, and 1 1/2"x12". Blade width selection is based on
equipment and operating condidtions. The following guidelines may be used to
determine blade width: "V" plows, 12" width; front-mounted plows, 10" width;
underbody-mounted plows and graders, 8"width.
Lengths: The blades may be ordered from distributors cut to any length,
and slotted for mounting, to meet your exact specifications. Bulk users may
order individual lengths or rubber blade stock in 50-ft lengths.
Bolt Holes: Mounting holes may be slotted or drilled. Slotting is
recommended to permit blade adjustment for maximum wear and service life.
Drillin, is acceptable in many applications - where the blade is subject to an
undue amount of pressure because of plow weight or abnormally high crowned
Adjustment: It is recommended that rubber snow plow blades be adjusted to
the type of equipment on which they are installed. Front-mounted plows that ride
on casters or shoes perform best with a 2" overhang. A 1" extension beyond the
moldboard is suggested for unsupported front-mounted, underbody-mounted plows,
The Most Common sizes are:
* 1 1/2" thick x 12" wide - V plows
* 1 1/2" thick x 10" wide - Front mounted plows supported by wheels or shoes
* 1 1/2" thick x 8" wide - Underbody mounted plow and graders. Unsupported front
mounted plows and graders.
* 1" thick x 6" wide - Jeeps and pickup trucks
L = overall length in inches
W = width in inches
T = thickness in inches
E = distance from end of blade to center
S = distance from center to center of intermediate holes or slot- inches of 1st
hole or slot-inches.
D = distance from point of angle to end of blade-inches